Power Trim/Tilt Switch Inspection (Outboard Motor Side); Trim Angle Sensor Inspection - TOHATSU BFT75A Service Manual

dummyhead dummyhead
OTHER ELECTRICAL
POWER TRIM/TILT SWITCH
INSPECTION (OUTBOARD MOTOR
SIDE)
Remove the engine cover.
Disconnect the power trim/tilt switch 3P connector [1].
Attach the tester lead to each terminal and check for
continuity.
When the switch is pushed "UP" or "DN", there should
be continuity between the terminals marked with a
circle in the table below.
Switch position
UP
Neutral
DN (Down)

TRIM ANGLE SENSOR INSPECTION

Remove the engine cover.
Disconnect the trim angle sensor 3P connector [1].
Measure the resistance between the trim angle sensor
3P connector sensor side terminals.
Between Light green/Black and Black
Between Yellow/Blue and Black
10-16
Color
W/Bl
Lb
4.0 – 6.0 kΩ
2.7 – 4.3 kΩ
Lg
[1]
[1]