Lower Unit
12) Assembly of Propeller Shaft Housing
1.
Use a press to push new needle bearing into propeller shaft
bearing to specified depth.
• Install needle bearing with manufacturer's
marking a facing reverse gear (C gear) side.
• Screw needle bearing attachment 2 into
driver rod 1 gently by using hand without
making gap.
Driver Rod 1 :
P/N. 3AC-99702-0
Needle Bearing Attachment 2 :
P/N. 3AC-99710-0
Center Plate 3 :
P/N. 3AC-99701-0
Push In Depth b :
51.0 ±0.25 mm(2.008 ±0.010 in)
2.
Apply engine oil to periphery of new oil seal, and install into
propeller shaft housing with number side facing upward.
Apply grease to lip of oil seal after installing it.
Driver Rod 1 :
P/N. 3AC-99702-0
Oil Seal Attachment 2 4 :
P/N. 3AD-99820-0
Use a press and suitable mandrel 8 to install new ball
3.
bearing 5 onto reverse gear (C gear).
Driver Rod 1 :
P/N. 3AC-99702-0
Bearing Attachment 7 :
P/N. 3AC-99905-0
Use a press and suitable mandrel 8 to install reverse gear
4.
(C gear) ass'y into propeller shaft housing.
6-14
1
3
b
OBM
OBM
OBM
1
7
8
8
b
a
2
1
4
6
5
25/30 2006