36
INSTALLATION
ENOM00641-0
5. Installing the drag link assembly
Incorrect or unstable installation of the
Drag Link Assembly can result in accidents
while riding the boat or breakage of the
hull.
Installation of the Drag Link Assembly by
your dealer is highly recommended.
1. Connect the Drag Link Rod to the tip
of the steering cable.
Tighten the rod using self-locking nut,
making sure the rod can swing freely.
2. Connect the other tip of the rod to the
steering bracket with a bolt, applying a
collar and washer. The bolt head must
face downward. Secure with a split pin
to the bolt.
ENON00605-0
Note
Depending on the steering cable manufac-
turer, spacers (optional) may by required.
ENON00606-0
Note
Apply grease in required places. (Refer to
the illustration below)
Apply grease inside the bracket bolt.
30, 40, 50
1
2
4
5
6
7
8
9
6
1. Apply grease inside the Bracket bolt
2. Grease
3. Steering bracket
4. Spacer (optional)
5. Split pin
6. Collar
7. Washer
8. Bolt
9. Rod
10. Self locking type nut
11. Apply grease on tip of Steering cable
12. Seal ring
75, 90, 115
1
3
4
5
6
5
7
8
1. Grease
2. Apply grease inside the Bracket bolt
3. Spacer (optional)
4. Nut
5. Washer
6. Collar
7. Bolt
8. Drag link rod
9. Steering bracket
3
11
12
2
7
10
ENOF00639-0
2
9
10
11
1
5
12
ENOF00640-0