H3C s3600 series Command Manual page 1059

Description
Use the tftp source-interface command to specify the source interface of a TFTP client that the TFTP
client uses every time it connects to a TFTP server. The system prompts that the configuration fails if the
specified interface does not exist.
Use the undo tftp source-interface command to cancel the source interface setting. The switch uses
the IP address of the outbound interface in the local routing table as the source IP address to connect to
a TFTP server. The destination of the outbound interface is the subnet where the TFTP server resides
By default, no source interface is specified for the switch to connect to the TFTP server.
Examples
# Specify VLAN-interface 1 as the source interface that the TFTP client uses every time it connects to a
TFTP server.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] tftp source-interface Vlan-interface 1
tftp source-ip
Syntax
tftp source-ip ip-address
undo tftp source-ip
View
System view
Parameters
ip-address: The source IP address that the switch uses every time it connects to a TFTP server.
Description
Use the tftp source-ip command to specify the source IP address that a TFTP client uses every time it
connects with a TFTP server. The specified IP address must exist; otherwise, a prompt appears to show
the configuration fails.
Use the undo tftp source-ip command to cancel the source IP address setting. The switch uses the IP
address of the outbound interface in the local routing table as the source IP address to connect to a
TFTP server. The destination of the outbound interface is the subnet where the TFTP server resides.
By default, no source IP address is specified for the switch to connect to the TFTP server.
Examples
# Specify 192.168.0.1 as the source IP address that the TFTP client uses every time it connects to a
TFTP server.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] tftp source-ip 192.168.0.1
2-6