35.2
35.2.1
Requirements
Configure access to
Internet step-by-step
NTRIP via Internet
Configuring a Real-Time Rover for Using NTRIP Service
Configuring an Access to the Internet
•
Firmware v1.5 or higher must be loaded on the GPS1200+ receiver.
•
Firmware v1.42 or higher must be loaded on the RX1200.
To access to the Internet with a GPS1200+ receiver, General Packed Radio System devices
will normally be used. GPRS is a telecommunication standard for transmitting data packages
using the Internet Protocol (IP).
A GPRS device can be connected in a clip-on-housing or with RX1250 via Bluetooth.
The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step
Description
1.
Refer to "22.2 Accessing Configuration Interfaces" to access
CONFIGURE Interfaces.
2.
In CONFIGURE Interfaces highlight Internet.
3.
EDIT (F3) to access CONFIGURE Internet Interface.
4.
CONFIGURE Internet Interface
<Internet: Yes:>
<IP Address: Dynamic>
GPS1200+
Refer to
chapter
22.11
770