Set Lacp Singleportlag; Clear Lacp Singleportlag - Enterasys SecureStack C2 C2G170-24 Configuration Manual

set lacp singleportlag

set lacp singleportlag
Use this command to enable or disable the formation of single port LAGs.
Syntax
set lacp singleportlag {enable | disable}
Parameters
disable | enable
Defaults
None.
Mode
Switch command, read‐write.
Usage
When single port LAGs are enabled, Link Aggregration Groups can be formed when only one
port is receiving protocol transmissions from a partner. When this setting is disabled, two or more
ports are required to form a LAG.
This setting has no effect on existing LAGs created with multiple member ports. It also does not
prevent previously formed LAGs from coming up after they have gone down, as long as any
previous LAG member ports come up connected to the same switch as before the LAG went
down.
Example
This example enables the formation of single port LAGs:
C2(su)->set lacp singleportlag enable

clear lacp singleportlag

Use this command to reset the single port LAG function back to the default state of disabled.
Syntax
clear lacp singleportlag
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
7-46 Port Configuration
Enables or disables the formation of single port LAGs.