Clear Lacp Static; Set Lacp Singleportlag - Enterasys SecureStack C2 Configuration Manual

clear lacp static

Defaults
If not specified, a key will be assigned according to the specified aggregator. For example a key of
4 would be assigned to lag.0.4.
Mode
Switch command, read‐write.
Example
This example shows how to add port
C2(su)->set lacp static lag.0.6 ge.1.6
clear lacp static
Use this command to remove specific ports from a Link Aggregation Group.
Syntax
clear lacp static lagportstring port-string
Parameters
lagportstring
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to remove
C2(su)->clear lacp static lag.0.6 ge.1.6

set lacp singleportlag

Use this command to enable or disable the formation of single port LAGs.
Syntax
set lacp singleportlag {enable | disable}
Parameters
disable | enable
5-40 Port Configuration
.1.6 to the LAG of aggregator port 6:
ge
Specifies the LAG aggregator port from which ports will be removed.
Specifies the port(s) to remove from the LAG. For a detailed description of
possible port‐string values, refer to "Port String Syntax Used in the CLI"
on page 5‐2.
.1.6 from the LAG of aggregator port 6:
ge
Enables or disables the formation of single port LAGs.