4.5.4.10
set singleportlag
Use this command to enable or disable the formation of single port LAGs. When enabled, this
maintains LAGs when only one port is receiving protocol transmissions from a partner.
set lacp singleportlag {enable | disable}
Syntax Description
enable | disable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable single port LAGs:
Matrix(rw)->set lacp singleportlag enable
Enables or disables the formation of single port LAGs.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Configuring LACP
Configuring Link Aggregation
4-111