Removing And Installing The Oil Filter Holder With The Engine Oil Cooler - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
❑ 20 Nm
14 - Gasket ring
❑ captive, replace if the oil pressure switch has leaks
Oil filter housing - tightening torque and tightening order
Note
Replace screws which have been tightened firmly to a torquing
angle.
– Attach the top left and bottom right screws first.
– Tighten screws in steps in the given sequence:
Stage Screws
1. -1 ... 5-
2. -1 ... 5-
1.4 Removing and installing the oil filter
holder with the engine oil cooler
Special tools and workshop equipment required
♦ Hose binding claw - VAS 6362-
Note
The engine oil cooler must not be disconnected from the oil filter
housing In the event of a defect, the engine oil cooler must be
replaced by the oil filter holder
⇒ "1.4 Removing and installing the oil filter holder with the engine
oil cooler", page 132 .
Removing
– Remove air filter
⇒ "6.5 Removing and installing air filter", page 364
– Remove fan shroud for radiator fan
⇒ "4.5 Removing and installing fan shroud", page 195
– Remove the front left coolant pipe
⇒ "3.4 Removing and installing the front left coolant pipe",
page 175 .
– Remove the front right coolant pipe
⇒ "3.5 Removing and installing the front right coolant pipe",
page 177 .
132
Rep. gr.17 - Lubrication
Tightening torque/torqueing angle
20 Nm
Turn 90° further
.
.