Chrysler 2005 Crossfire SRT6 Service Manual page 3476

21 - 406 MANUAL - SERVICE INFORMATION
INSTALLATION
1. Install the shift handle (1) on the shift rod (4).
2. Tighten the retainer nut (3) counterclockwise
(upward) until it is snug.
3. Push the shifter cover (2) down over the retainer
and shift rod (4).
REVERSE LOCKOUT CABLE
DESCRIPTION
Reverse gear, which is selected by moving the lever to the left and back (toward the driver) from first gear is pro-
tected against accidental selection by the lockout cable. The lockout cable requires that the knob must be lifted
before selecting reverse or the movement will be blocked. The reverse gear lockout cable is serviced only with the
shift mechanism. If the cable becomes inoperable, the shift mechanism must be replaced. (Refer to 21 - TRANS-
MISSION/TRANSAXLE/MANUAL/SHIFT MECHANISM - REMOVAL).
STANDARD PROCEDURE - REVERSE LOCKOUT CABLE ADJUSTMENT
1. Remove the leather shifter boot (1) from the shifter
bezel (2).
2. Pull the leather shifter boot up over the shifter
knob.
ZH