Chrysler 2005 Crossfire SRT6 Service Manual page 3442

21 - 372 MANUAL - SERVICE INFORMATION
3. Stake the output shaft nut to the output shaft as
follows.
a. Place the Special Tool 9078 Staking Tool (2)
onto the output shaft.
b. Rotate the Special Tool 9078 Staking Tool (2)
until the alignment pin (3) engages the output
shaft notch (4).
c. Press downward on the staking tool (1) until
the staking pin (3) contacts the output shaft nut
flange (2).
d. Strike Special Tool 9078 Staking Tool with a
suitable hammer until the output shaft nut is
securely staked to the output shaft.
4. Install the propeller shaft. (Refer to 3 - DIFFERENTIAL & DRIVELINE/PROPELLER SHAFT - INSTALLATION).
5. Check the transmission fluid level. (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL/FLUID - STANDARD
PROCEDURE).
6. Lower the vehicle.
ZH