Chrysler 2005 Crossfire SRT6 Service Manual page 3123

ZH
(P0600) ENGINE TEMPERATURE MESSAGE (CONTINUED)
2.
(P0720) CAN BUS CIRCUIT DTC PRESENT
Turn the ignition on.
With the DRB III , read Transmission DTCs.
Note: If DTC (P0720) CAN BUS CIRCUIT is present, perform diag-
nostics on that symptom first.
Is DTC (P0720) CAN BUS CIRCUIT present?
Yes >> Refer to the Transmission - Electrical Diagnostics category
and perform the appropriate symptom.
No >> Go To 3
3.
CHECK TO SEE IF ENGINE DTCS ARE PRESENT
With the ignition on.
With the DRB III , read Engine DTCs.
Are any Engine Coolant Temperature Sensor DTCs present?
Yes >> Refer to the Engine - Electrical Diagnostics category and
perform the appropriate symptom.
No >> Go To 4
4.
PCM - ENGINE TEMP MESSAGE
Turn the ignition off.
Replace and program the Powertrain Control Module. (Refer to 8 -
ELECTRICAL/ELECTRONIC
CONTROL MODULE - REMOVAL).
Turn the ignition on.
With the DRB III , erase Transmission DTCs.
Start the engine.
With the brakes firmly applied, shift the gear selector into drive.
With the DRB III , read Transmission DTCs.
Did DTC (P0600) ENGINE TEMPERATURE MESSAGE set again?
Yes >> Replace the Transmission Control Module. (Refer to 8 -
ELECTRICAL/ELECTRONIC
TRANSMISSION CONTROL MODULE - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Test Complete.
CONTROL MODULES/POWERTRAIN
CONTROL
NAG1 - ELECTRICAL DIAGNOSTICS 21 - 53
MODULES/