19 - 66
LINKAGE
INSTALLATION
1. Clean the tapered surfaces, and remove any
grease or debris from the tie rod end.
2. Thread the tie rod end onto the drag link.
3. Install the tie rod end to the steering knuckle.
4. Install the attaching nut on the tie rod end. Tighten
to 50 N·m (37 ft. lbs.).
5. Thread the jam nut down far enough to hold the tie
rod end in place. Do not tighten the jam nut.
6. Adjust the front toe setting on the vehicle. (Refer to
2 - SUSPENSION/WHEEL ALIGNMENT - STAN-
DARD PROCEDURE).
ZH