Chrysler 2005 Crossfire SRT6 Service Manual page 3218

21 - 148 NAG1 - ELECTRICAL DIAGNOSTICS
(P0758) 2-3 SOLENOID CIRCUIT (CONTINUED)
2.
CHECK FOR CURRENT DTC
Note: If the TCM detects and stores a DTC, the TCM also stores the engine/vehicle operating conditions
under which the DTC was set. Some of these conditions are displayed on the DRB III at the same time the
DTC is displayed.
Note: Before erasing stored DTCs, record these conditions. Attempting to duplicate these conditions may
assist when checking for an active DTC.
Turn the ignition on.
With the DRB III , erase Transmission DTCs.
Note: It maybe necessary to road test the vehicle for this DTC to set.
With the DRB III , read Transmission DTCs.
Did this DTC set again?
Yes >> Go To 3
No >> Go To 7
3.
2-3 SOLENOID CONTROL CIRCUIT OPEN
Turn the ignition off.
Disconnect the Transmission Control Module C2 harness connector.
Disconnect the Transmission Solenoid Assembly harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the 2-3 Solenoid Control circuit from the
TCM C2 harness connector to the Transmission Solenoid Assembly
harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 4
No >> Repair the 2-3 Solenoid Control circuit for an open.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
ZH