Chrysler 2005 Crossfire SRT6 Service Manual page 3198

21 - 128 NAG1 - ELECTRICAL DIAGNOSTICS
(P0740) TCC STUCK ON (CONTINUED)
3.
TCC SOLENOID CONTROL CIRCUIT SHORT TO GROUND
Turn the ignition off.
Disconnect the TCM C2 harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the TCC Solenoid Con-
trol circuit.
Is the resistance above 100 kohms?
Yes >> Go To 4
No >> Repair the TCC Solenoid Control circuit for a short to
ground.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
4.
TCC SOLENOID CONTROL CIRCUIT SHORT TO OTHER CIRCUITS
With the ignition off.
Measure the resistance from the TCC Solenoid Control circuit to all
other circuits in the Transmission Solenoid Assembly harness connec-
tor.
Is the resistance above 100 kohms for all measurements?
Yes >> Repair the TCC Solenoid Control circuit for a short to
other circuit(s).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Replace the Transmission Control Module. (Refer to 8 -
ELECTRICAL/ELECTRONIC
TRANSMISSION CONTROL MODULE - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
CONTROL MODULES/
ZH