Chrysler 2005 Crossfire SRT6 Service Manual page 3380

21 - 310 AUTOMATIC - NAG1 SERVICE INFORMATION
5. Remove the remaining screws (3) and the trans-
mission pan (1).
6. Remove and discard the transmission filter (6) from
the valve body.
7. Clean the transmission oil pan and the gasket sur-
face of the transmission.
8. Install a new transmission filter (6).
9. Replace the transmission pan gasket if damaged or
swollen.
10. Install the transmission pan (1) and bolts (3).
Tighten the bolts to 8 N·m (71 in. lbs.).
11. Install the drain plug (2) with a new gasket (1).
Tighten the drain plug to 20 N·m (15 lbs.ft.).
12. Install the heat shield and the bolts (2). Tighten
the bolts to 8 N·m (71 in. lbs.).
13. Route the oxygen sensor wire harness (1) in the
heat shield. Connect the oxygen sensor wire har-
ness connectors.
14. Lower the vehicle.
15. Fill the transmission with the specified fluid.
ZH