Chrysler 2005 Crossfire SRT6 Service Manual page 3288

21 - 218 AUTOMATIC - NAG1 SERVICE INFORMATION
CONDITION
HARD 2-3 UPSHIFT WHEN
STEPPING OFF THE
ACCELERATOR PEDAL
UPSHIFT 2-3, 3-4
SLIPPING
HARD 2-1 DOWNSHIFT
WHEN COMING TO A
STOP
HARD 3-2 DOWNSHIFT
WHEN DECELERATION
EVEN AFTER
READAPTION
NO RESP. DELAYED
UPSHIFT, NO DTC
NO UPSHIFT 3-4, 4-5
AFTER FAST OFF
(ACCELERATOR)
NO UPSHIFT OF 1ST
GEAR BELOW 5000 RPM
NO UPSHIFT INTO 5TH
GEAR WHEN FULL
THROTTLE OR KICK
DOWN ACTIVATION
NO KICK DOWN
SHIFTING
ENGINE TURNS UP
WHILE 2-3 UPSHIFT
AND/OR HARD 3-2
DOWNSHIFT
GRABBING 2-3 COASTING
UPSHIFT AND/OR BRAKE
DOWNSHIFT
POSSIBLE CAUSES
1. Response Characteristic Control
Loop.
1. Spring of Regulating Valve
Pressure control Valve Broken.
1. Transmission (2-1 downshift) not
Adapted.
2. TCM Software Data.
3. Freewheel F1 Defective.
1. K3 Idles.
1. Different Tire Sizes are Mounted
on the Front Axle.
1. Upshift Prevention to Realize
Dynamical Drivestyle.
1. Gear Recognition Switch.
1. The Upshift 4-5 at Full Throttle or
Kick Down Never Occurs Until
Reaching Cut Off Speed. Under
These Conditions, the High Powered
Vehicle Will Never Shift Into 5th
Gear Below 250 km/h.
1. Accelerator Pedal Value < 95%.
1. Oil Level too Low.
2. Oil Filter not Installed.
3. Freewheel F2 Defective.
1. Oil Level too Low.
2. Oil Filter not Installed.
3. Control Shift or Command Valve
Blocked.
4. K3 Disc Burnt, Hot Spots or
Rubbed Down.
CORRECTION
1. Install K2 Disc Spring.
1. Replace Spring.
1. Re-adapt Transmission.
2. Flash TCM.
3. Replace Freewheel F1.
1. Install TCM and/or
Electrohydraulic Control Unit.
1. Mount Uniform Tire Sizes on
the Front Axle.
1. Instruct Customer.
1. Replace Gear Recognition
Switch.
1. Instruct Customer.
1. Check Engine Control. Adjust
as Necessary.
1. Check Oil Level. Add if
Necessary.
2. Install Oil Filter.
3. Replace Freewheel F2,
Hollow Shaft, and Rear Sun
Gear/Inner Disc Carrier K3.
1. Check Oil Level. Add if
Necessary.
2. Install Oil Filter.
3. Check Each Slide Valve for
Base Position and Ease of
Movement, Remove Particle.
4. Replace Inner and Outer
Disc Carrier K3 and Control
Valve.
ZH