Chrysler 2005 Crossfire SRT6 Service Manual page 3308

21 - 238 AUTOMATIC - NAG1 SERVICE INFORMATION
35. Install the guide bushing (12).
36. Install the torque converter (1). (Refer to 21 -
TRANSMISSION/TRANSAXLE/AUTOMATIC
NAG1/TORQUE CONVERTER - INSTALLATION).
INSTALLATION
1. Inspect the rear crankshaft seal area for signs of leakage. Replace the seal if required. (Refer to 9 - ENGINE/
ENGINE BLOCK/CRANKSHAFT OIL SEAL - REAR - REMOVAL).
2. Ensure the torque converter is fully seated in the transmission. Mount the transmission on the transmission jack.
3. Position the transmission in the vehicle on the engine block dowels.
4. Install the transmission retaining bolts and the ground cable. Tighten the bolts to 38 N·m (28 ft. lbs.).
Note: Rotate the engine at the vibration damper bolt.
5. Install the torque converter bolts. Tighten the bolts to 50 N·m (37 ft. lbs.).
6. Install the torque converter access cover (1).
7. Install the starter. (Refer to 8 - ELECTRICAL/
STARTING/STARTER MOTOR - INSTALLATION).
-
ZH