Chrysler 2005 Crossfire SRT6 Service Manual page 3164

21 - 94 NAG1 - ELECTRICAL DIAGNOSTICS
(P0715) INPUT SENSOR MISMATCH (CONTINUED)
2.
SPEED SENSOR DTCS PRESENT
With the ignition on.
With the DRB III , read Transmission DTCs.
Are any Speed Sensor or Sensor Supply DTCs present?
Yes >> Repair any Speed Sensor and/or Sensor Supply DTCs
before proceeding with test.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Go To 3
3.
CHECK TO SEE IF INPUT SENSOR MISMATCH IS CURRENT
Turn the ignition on.
With the DRB III , erase Transmission DTCs.
Start the engine.
Drive the vehicle at speeds to allow multiple 2-3 and 3-4 upshifts.
With the DRB III , read Transmission DTCs.
Did DTC (P0715) INPUT SENSOR MISMATCH set again?
Yes >> Go To 4
No >> Go To 5
4.
INTERNAL TRANSMISSION
Turn the ignition off.
Remove the Transmission Oil Pan and inspect for debris or a plugged Transmission Oil Filter.
Is there any debris, plugged Transmission Oil Filter, or sign of an internal transmission problem?
Yes >> Repair the internal transmission as necessary. Refer to the Transmission - Service Information for
proper repair procedures.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Replace the Transmission Control Module. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MOD-
ULES/TRANSMISSION CONTROL MODULE - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
ZH
2