Chrysler 2005 Crossfire SRT6 Service Manual page 3569

ZH
REAR SPOILER LIMIT SWITCH FAILURE (CONTINUED)
3.
SPOILER LIMIT SWITCH SIGNAL (DOWN) CIRCUIT SHORTED TO GROUND
Turn the ignition off.
Disconnect the BCM C4 harness connector.
Measure the resistance between ground and the Spoiler Limit Switch
(Down) circuit.
Is the resistance below 100k ohms?
Yes >> Repair the Spoiler Limit Switch Signal (Down) circuit for a
short to ground.
Perform REAR SPOILER VERIFICATION TEST.
No >> Replace the Body Control Module.(Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL).
Perform REAR SPOILER VERIFICATION TEST.
4.
SPOILER LIMIT SWITCH SIGNAL (UP) CIRCUIT SHORT TO GROUND
Turn the ignition off.
Disconnect the BCM C4 harness connector.
Measure the resistance between ground and the Spoiler Limit Switch
(Up) circuit.
Is the resistance below 100k ohms?
Yes >> Repair the Spoiler Limit Switch Signal (Up) circuit for a
short to ground.
Perform REAR SPOILER VERIFICATION TEST.
No >> Replace the Body Control Module.(Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL).
Perform REAR SPOILER VERIFICATION TEST.
BODY - ELECTRICAL DIAGNOSTICS 23 - 21