Chrysler 2005 Crossfire SRT6 Service Manual page 3172

21 - 102 NAG1 - ELECTRICAL DIAGNOSTICS
(P0715) N2 INPUT SPEED SENSOR CIRCUIT (CONTINUED)
4.
N2 INPUT SPEED SENSOR SIGNAL CIRCUIT OPEN
With the ignition off.
Measure the resistance of the N2 Input Speed Sensor Signal circuit
from the TCM C2 harness connector to the Transmission Solenoid
Assembly harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 5
No >> Repair the N2 Input Speed Sensor Signal circuit for an
open.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
5.
SENSOR GROUND CIRCUIT OPEN
With the ignition off.
Measure the resistance of the Sensor Ground circuit from the TCM C2
harness connector to the Transmission Solenoid Assembly harness
connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 6
No >> Repair the Sensor Ground circuit for an open.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
ZH