Chrysler 2005 Crossfire SRT6 Service Manual page 3346

21 - 276 AUTOMATIC - NAG1 SERVICE INFORMATION
ASSEMBLY
1. Install the piston (6) in the outer multiple-disc carrier. Inspect the seals (4 and 5), replace if necessary. The
rounded edges of the seals must point to the outside.
2. Insert the disc spring (7) and the spring retainer (9). Insert the disc spring (7) with the curved side pointing
toward the spring retainer (9). Inspect the seal (8), replace if necessary.
3. Place Special Tool 8900 on the spring plate (1) and
press until the groove of the snap-ring is exposed.
4. Insert the snap-ring (2).
5. Insert the disc spring.
Note: Pay attention to the sequence of the discs.
Place new friction multiple-discs in ATF fluid for
one hour before installing.
6. Insert the multiple-disk set into the outer multiple-
disk carrier.
7. Fit the snap-ring.
ZH