Table of Contents
Advertisement
ZH
ASSEMBLY
1. Install the piston (6) in the K1 outer disc carrier (1). Check the sealing rings (4 and 5) and replace if necessary.
The rounded off edges of the sealing rings must point outwards.
2. Insert the disc spring (7). Insert the disc spring with the curvature towards the piston.
3. Insert the spring plate (8). Insert the spring plate with the curvature towards the sun gear. Check the sealing ring
(9), replace if necessary.
4. Place Special Tool 8900 on spring plate (8) and compress the spring until the groove of the snap-ring is
exposed.
5. Insert the snap-ring (10). After installing, check the snap-ring for correct seat.
Note: Pay attention to the sequence of the discs. Place new friction multiple-discs in ATF fluid for one hour
before installing.
6. Insert the multiple disc pack (12) in the K1 outer disc carrier (1).
7. Insert the snap-ring (11).
8. Measure the K1 clutch pack clearance.
AUTOMATIC - NAG1 SERVICE INFORMATION 21 - 271
Advertisement
Chapters
Table of Contents
