Chrysler 2005 Crossfire SRT6 Service Manual page 3094

21 - 24 NAG1 - ELECTRICAL DIAGNOSTICS
(P0600) ABS LEFT FRONT SENSOR MESSAGE (CONTINUED)
2.
(P0720) CAN BUS CIRCUIT DTC PRESENT
Turn the ignition on.
With the DRB III , read Transmission DTCs.
Note: If DTC (P0720) CAN BUS CIRCUIT is present, perform diag-
nostics on that symptom first.
Is DTC (P0720) CAN BUS CIRCUIT present?
Yes >> Refer to the Transmission - Electrical Diagnostics category
and perform the appropriate symptom.
No >> Go To 3
3.
CHECK TO SEE IF ABS DTCS ARE PRESENT
With the ignition on.
With the DRB III , read ABS DTCs.
Are any ABS DTCs present?
Yes >> Refer to the Brakes - ABS Electrical Diagnostics category
and perform the appropriate symptom.
No >> Go To 4
4.
CONTROLLER ANTILOCK BRAKE
Turn the ignition off.
Replace the Controller Antilock Brake. (Refer to 8 - ELECTRICAL/
ELECTRONIC CONTROL
BRAKE - REMOVAL).
Turn the ignition on.
With the DRB III , erase Transmission DTCs.
Road test the vehicle.
With the DRB III , read Transmission DTCs.
Did DTC (P0600) ABS LEFT FRONT SENSOR MESSAGE set
again?
Yes >> Replace the Transmission Control Module. (Refer to 8 -
ELECTRICAL/ELECTRONIC
TRANSMISSION CONTROL MODULE - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Test Complete.
MODULES/CONTROLLER
CONTROL
ANTILOCK
MODULES/
ZH