Chrysler 2005 Crossfire SRT6 Service Manual page 3643

ZH
9650 TONNEAU COVER CYLINDER TRAVEL SENSOR +/- CIRCUIT OPEN/SHORT TO
GROUND (CONTINUED)
• When Monitored: Continuous with the ignition on.
• Set Condition: When the Power Top Control Module senses a open or a short to ground on the Ton-
neau Cover Cylinder Travel Sensor +/- circuit.
TONNEAU COVER TRAVEL SENSOR
POWER TOP CONTROL MODULE
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.
Diagnostic Test
1.
Monitor the Tonneau Cover Cylinder Travel Sensor
Turn the ignition on.
The Convertible Top must be up and locked.
With the DRB III , select Sensors Display and monitor the TON CVR
TRVL SEN ROD.
Does the DRB III
70–85 Counts?
Yes >> Go To 3
No >> Go To 2
2.
Power Top Control Module
Turn the ignition off.
Disconnect the Power Top Control Module C2 harness connector.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
With the DRB III , select Sensor Display and monitor the TON CVR
TRL SEN ROD.
With a fused jumper wire, momentarily connect the jumper between
the Tonneau Cover Cylinder Travel Sensor (+) circuit and the (-) circuit
at the PTCM.
With the jumper wire connected, does the DRB III , display,
TON CVR TRL SEN ROD above 100 Counts?
Yes >> Replace the Tonneau Cover Cylinder Travel Sensor.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC CONTROL MODULES/POWER TOP CONTROL MODULE - REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICATION TEST.
display TON CVR TRL SEN ROD between
Possible Causes
CONVERTIBLE TOP 23 - 95