Chrysler 2005 Crossfire SRT6 Service Manual page 3154

21 - 84 NAG1 - ELECTRICAL DIAGNOSTICS
(P0702) SOLENOID SUPPLY/WATCHDOG (CONTINUED)
5.
SOLENOID SUPPLY VOLTAGE CIRCUIT SHORT TO ANOTHER CIRCUIT
Turn the ignition off.
Disconnect the Transmission Solenoid Assembly harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance from the Solenoid Supply Voltage circuit to all
other circuits in the Transmission Solenoid Assembly harness connec-
tor.
Is the resistance above 100 kohms for all measurements?
Yes >> Replace the Transmission Control Module. (Refer to 8 -
ELECTRICAL/ELECTRONIC
TRANSMISSION CONTROL MODULE - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Repair the Solenoid Supply Voltage circuit for a short to
other circuit(s).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
6.
SOLENOID CONTROL CIRCUIT SHORT TO VOLTAGE
Turn the ignition off.
Disconnect the TCM C2 harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of each of the Solenoid Control circuits in the
Transmission Solenoid Assembly harness connector.
Is the voltage below 1.0 volt for each measurement?
Yes >> Replace the Transmission Control Module. (Refer to 8 -
ELECTRICAL/ELECTRONIC
TRANSMISSION CONTROL MODULE - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Repair the Solenoid Control circuit that measured above
1.0 volt for a short to voltage.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
CONTROL MODULES/
CONTROL MODULES/
ZH