ZH
(P0600) ACCEL PEDAL SENSOR CAN MESSAGE INCORRECT (CONTINUED)
5.
CHECK TO SEE IF ENGINE DTCS ARE PRESENT
With the ignition on.
With the DRB III , read Engine DTCs.
Are any Engine APP Sensor or TP Sensor DTCs present?
Yes
>> Refer to the Engine - Electrical Diagnostics category and
perform the appropriate symptom.
No
>> Go To 6
6.
TCM - ENGINE TPS MESSAGE
Turn the ignition off.
Replace the Transmission Control Module. (Refer to 8 - ELECTRICAL/
ELECTRONIC CONTROL MODULES/TRANSMISSION CONTROL
MODULE - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
Turn the ignition on.
With the DRB III , read Transmission DTCs.
Did DTC (P0600) ACCEL PEDAL SENSOR CAN MESSAGE
INCORRECT set again?
Yes
>> Replace and program the Powertrain Control Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/POWERTRAIN
REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No
>> Test Complete.
7.
INTERMITTENT WIRING AND CONNECTORS
The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible
intermittent condition.
Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
Wiggle the wires while checking for shorts and open circuits.
Note: Check for any Technical Service Bulletins that may apply.
Were any problems found?
Yes
>> Repair as necessary.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No
>> Test Complete.
CONTROL
MODULE
NAG1 - ELECTRICAL DIAGNOSTICS 21 - 37
-