Chrysler 2005 Crossfire SRT6 Service Manual page 3305

ZH
23. Install the output shaft bearing in the rear trans-
mission housing.
a. Using Special Tool 9287 (1), install the output
shaft bearing (2) into the transmission housing
(3). The closed side of the plastic cage
must point towards the parking lock gear.
b. Install the retaining ring (1). Ensure that the
retaining ring (1) is seated correctly in the
groove.
c. Check that there is no play between the bear-
ing (2) and the retaining ring (1) using a feeler
gauge.
d. There must be no play between the retaining
ring (1) and the bearing (2). If the ring cannot
be installed, a thinner ring must be used. If
there is play between the ring (1) and the bear-
ing (2), a thicker ring must be installed. Retain-
ing rings are available in thicknesses of 2.0
mm (0.079 in.), 2.1 mm (0.083 in.), and 2.2
mm (0.087 in.).
24. Rotate the transmission so that the bellhousing is
pointed upward and ensuring that the output shaft
is allowed to move freely.
AUTOMATIC - NAG1 SERVICE INFORMATION 21 - 235