Chrysler 2005 Crossfire SRT6 Service Manual page 3140

21 - 70 NAG1 - ELECTRICAL DIAGNOSTICS
(P0700) SENSOR SUPPLY VOLTAGE (CONTINUED)
2.
CHECK FOR CURRENT DTC
Note: If the TCM detects and stores a DTC, the TCM also stores
the engine/vehicle operating conditions under which the DTC was
set. Some of these conditions are displayed on the DRB III at the
same time the DTC is displayed.
Note: Before erasing stored DTCs, record these conditions.
Attempting to duplicate these conditions may assist when check-
ing for an active DTC.
Turn the ignition on.
With the DRB III , erase Transmission DTCs.
Note: It maybe necessary to road test the vehicle for this DTC to
set.
With the DRB III , read Transmission DTCs.
Did this DTC set again?
Yes >> Go To 3
No >> Go To 5
3.
SENSOR SUPPLY VOLTAGE CIRCUIT SHORT TO OTHER CIRCUITS
Turn the ignition off.
Disconnect the Transmission Solenoid Assembly harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance from the Sensor Supply Voltage circuit to all
other circuits in the Transmission Solenoid harness connector.
Is the resistance above 100 kohms for all measurements?
Yes >> Go To 4
No >> Repair the Sensor Supply Voltage circuit for a short to
other circuit(s).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
ZH