Chrysler 2005 Crossfire SRT6 Service Manual page 3365

ZH
7. Unscrew the bolts (3) and remove electrohydraulic
control module (2).
DISASSEMBLY
1. Remove the electrohydraulic control unit from the
vehicle. (Refer to 21 - TRANSMISSION/TRANS-
AXLE/AUTOMATIC - NAG1/ELECTROHYDRAULIC
UNIT - REMOVAL).
2. Remove the solenoid caps (1, 2).
3. Unscrew the bolts (3, 4).
Note: Pay attention to the different lengths of the
Torx socket bolts.
4. Remove the leaf springs (5).
5. Withdraw the solenoid valves (6 - 11) from the shift
plate (13).
Note: Check O-rings on solenoid valves for dam-
age and replace if necessary.
6. Bend away the retaining lug on the stiffening rib on
the transmission oil temperature sensor.
7. Remove the electrohydraulic control module (12) from the shift plate (13).
Note: Pay great attention to cleanliness for all work on the shift plate. Fluffy cloths must not be used.
Leather cloths are particularly good. After dismantling, all parts must be washed and blown out with com-
pressed-air, noting that parts may be blown away.
AUTOMATIC - NAG1 SERVICE INFORMATION 21 - 295