Chrysler 2005 Crossfire SRT6 Service Manual page 3379

ZH
STANDARD PROCEDURE - TRANSMISSION FILL
To avoid overfilling transmission after a fluid change or
overhaul, perform the following procedure:
1. Verify that the vehicle is parked on a level surface.
2. Remove the locking pin (1). Remove the plate of
the locking pin with a suitable tool and press out
the pin remaining in the cap downwards.
3. Remove the cap (2) from the fill tube (3).
4. Add the following initial quantity of Shell 3403 to
transmission:
a. If only the fluid and filter were changed, add
5.0 L (10.6 pts.) of transmission fluid to the
transmission.
b. If the transmission was completely overhauled,
the torque converter was replaced or drained,
and the cooler was flushed, add 7.7 L (16.3
pts.) of transmission fluid to the transmission.
5. Check the transmission fluid level. (Refer to 21 -
TRANSMISSION/TRANSAXLE/AUTOMATIC
NAG1/FLUID - STANDARD PROCEDURE), and adjust as required.
STANDARD PROCEDURE - FILTER CHANGE
1. Raise and support the vehicle.
2. Position a drain pan under the transmission drain plug. Remove the plug (2) and the gasket (1). Allow the trans-
mission to drain thoroughly.
3. Remove the oxygen sensor wire harness (1) from
the heat shield.
4. Remove the screws (2) from the heat shield and
position it out of the way.
AUTOMATIC - NAG1 SERVICE INFORMATION 21 - 309
-