Chrysler 2005 Crossfire SRT6 Service Manual page 3295

ZH
2. Place the transmission in a vertical position.
3. Measure the input shaft end play as follows.
a. Attach the Special Tool 8266-18 (2) to Special
Tool 8266-8 (1).
b. Attach the Special Tool C-3339 (3) and the
Special Tool 8266-8 (1).
c. Install the assembled tool onto the input shaft
of the transmission and tighten the retaining
screw on Special Tool 8266-18 (2) to secure it
to the input shaft.
d. Position the dial indicator plunger against a flat
spot on the oil pump and zero the dial indica-
tor.
e. Move the input shaft in and out. Record the
maximum travel for assembly reference.
4. Loosen the guide bushing (12) and remove it from
the transmission housing.
5. Remove the oil pan (5).
6. Remove the oil filter (4).
7. Unscrew the bolts (3) and remove the electrohy-
draulic unit (2).
8. Place the transmission in the PARK position before
attempting to remove the output shaft nut.
9. Remove the output shaft nut holding the propeller
shaft flange to the output shaft.
10. Remove the propeller shaft flange.
11. Remove the transmission rear oil seal with a suit-
able slide hammer and screw.
12. Remove the transmission output shaft washer. Be
sure to tag the washer since it is very similar to
the geartrain end-play shim and they must not be
interchanged.
AUTOMATIC - NAG1 SERVICE INFORMATION 21 - 225