Chrysler 2005 Crossfire SRT6 Service Manual page 3419

ZH
6. Check the converter seating with a scale and
straightedge. Surface of the converter lugs should
be at least 19 mm (3/4 in.) (3) to the rear of the
straightedge when converter is fully seated.
7. If necessary, temporarily secure the converter with
a C-clamp attached to the converter housing.
8. Install the transmission in the vehicle. (Refer to 21
- TRANSMISSION/TRANSAXLE/AUTOMATIC
NAG1 - INSTALLATION).
9. Fill the transmission with the recommended fluid.
TORQUE CONVERTER HUB SEAL
REMOVAL
1. Remove the torque converter. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - NAG1/TORQUE
CONVERTER - REMOVAL).
2. Remove the torque converter hub seal with suitable screw and slide hammer.
INSTALLATION
1. Position the torque converter hub seal (1) over the
input shaft (2) and against the transmission oil
pump.
AUTOMATIC - NAG1 SERVICE INFORMATION 21 - 349
-