Chrysler 2005 Crossfire SRT6 Service Manual page 3423

ZH
REMOVAL
1. Remove the front center console. (Refer to 23 -
BODY/INTERIOR/CENTER
REMOVAL).
2. Remove the gear shift lever handle.
3. Disconnect the wire harness connectors (2) at the
rear of the shift mechanism.
4. Remove the retaining bolts (3).
5. Lift the shift mechanim up and disconnect the shift
rod. Remove the shift mechanism from the vehicle.
INSTALLATION
1. Connect the shift rod to the shift mechanism and
install the retainer clip.
2. Position the shift mechanism (1) in the vehicle.
3. Install the retaining bolts (3). Tighten the bolts to 7
N·m (65 in. lbs.).
4. Connect the wire harness (2) connectors at the
rear of the shift mechanism.
5. Install the front center console. (Refer to 23 - BODY/INTERIOR/CENTER CONSOLE - INSTALLATION).
6. Install the gear shift lever handle.
GEAR SHIFT ROD
REMOVAL
1. Raise and support the vehicle.
2. Remove the retaining clip at the shifter (1).
AUTOMATIC - NAG1 SERVICE INFORMATION 21 - 353
CONSOLE -