21 - 294
AUTOMATIC - NAG1 SERVICE INFORMATION
REMOVAL
1. Move selector lever to position "P".
2. Raise and support the vehicle.
3. Remove the bolt (3) and screw (1) holding the heat
shield (2) to the transmission.
4. Loosen the guide bushing and remove it from the
transmission housing.
5. Disconnect the 13-pin plug connector (1). Turn the
bayonet
lock
of
anti-clockwise.
Note: If the transmission fluid is burnt or contains abraded particles, the oil cooler lines and oil cooler must
be flushed out.
6. Remove the transmission filter. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - NAG1/FLUID -
STANDARD PROCEDURE).
the
guide
bushing
(2)
ZH