Chrysler 2005 Crossfire SRT6 Service Manual page 3445

ZH
TRANSMISSION FRONT SECTION
DISASSEMBLY
1. Remove the transmission. (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL - REMOVAL).
2. Separate the front and rear transmission sections. (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL/
GEARTRAIN HOUSING - DISASSEMBLY).
3. Remove the locking plate bolts (4) and the locking plates (5).
4. Drive out the input shaft bearing (2) and the countershaft bearing (3).
5. Remove the shift shaft bearing (1).
6. Remove the guide sleeves (6).
ASSEMBLY
1. Drive in the sleeves (6) using a mallet.
2. Install the shift shaft bearing (1).
Note: The input and counter shaft bearings must be fully seated before installing the locking plates.
3. Install the input shaft bearing (2) and the countershaft bearing (3).
4. Install the locking plates (5) and bolts (4). Tighten the bolts to 9 N·m (7 ft. lbs.).
5. Assemble the front and rear transmission sections. (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL/
GEARTRAIN HOUSING - ASSEMBLY).
6. Install the transmission. (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL - INSTALLATION).
MANUAL - SERVICE INFORMATION 21 - 375