Chrysler 2005 Crossfire SRT6 Service Manual page 3433

ZH
10. Connect the pressure line (1) to the slave cylin-
der. Install the retaining bolt (2) to the transmis-
sion. Tighten the retaining bolt to 10 N·m (89 in.
lbs.).
11. Install the propeller shaft. (Refer to 3 - DIFFER-
ENTIAL & DRIVELINE/PROPELLER SHAFT -
INSTALLATION).
12. Fill the transmission. (Refer to 21 - TRANSMIS-
SION/TRANSAXLE/MANUAL/FLUID
DARD PROCEDURE).
13. Lower the vehicle.
14. Check the brake fluid level in master cylinder fluid
reservoir.
15. Bleed the clutch slave cylinder. (Refer to 6 -
CLUTCH - STANDARD PROCEDURE).
16. Recheck the brake fluid level.
17. Connect the negative battery cable.
18. Start the engine and check for leaks.
19. Check for proper clutch operation.
SPECIFICATIONS
SPECIFICATIONS - GEAR RATIOS
GEAR RATIOS
DESCRIPTION
Reverse Gear
-
1st Gear
2nd Gear
3rd Gear
4th Gear
5th Gear
6th Gear
MANUAL - SERVICE INFORMATION 21 - 363
STAN-
SPECIFICATION
4.46
2.61
1.72
1.25
1.00
0.84
4.06