Chrysler 2005 Crossfire SRT6 Service Manual page 3451

ZH
5. Install the four bolts (1) that attach the shifter plate
(2) to the rear section. Tighten the bolts to 28 N·m
(21 ft. lbs.).
6. Install the counter shaft bolt (5). Tighten the bolt to
90 N·m (66 ft. lbs.).
7. Install the snap ring (2) on the input shaft.
8. Use Special Tool 9123 Drift to drive in a new input
shaft seal.
9. Install a new sealing ring (6) in the counter shaft
bolt opening (4).
10. Install the clutch release bearing/slave cylinder.
(Refer to 6 - CLUTCH/SLAVE CYLINDER -
REMOVAL).
11. Apply a 1.5 to 2mm. bead of Loctite 5203 sealer
or equivalent to the front section as shown.
MANUAL - SERVICE INFORMATION 21 - 381