Chrysler 2005 Crossfire SRT6 Service Manual page 3693

ZH
9861 TRUNK LATCH ACTUATOR UNLOCK CONTROL CIRCUIT SHORT TO B(+) (CONTINUED)
4.
Open Trunk Latch Actuator Lock Control Circuit
With the ignition off.
Disconnect the Trunk Latch Assembly C2 harness connector.
Measure the resistance of the Trunk Latch Actuator Lock Control cir-
cuit from the Trunk Latch Assembly C2 harness connector to the
Power Top Control Module C1 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 5
No >> Repair the Trunk Latch Actuator Lock Control circuit for an
open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
5.
Open Trunk Latch Actuator Unlock Control Circuit
With the ignition off.
Measure the resistance of the Trunk Latch Actuator Unlock Control cir-
cuit from the Trunk Latch Assembly C2 harness connector to the
Power Top Control Module C1 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Trunk Latch Assembly.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Repair the Trunk Latch Actuator Unlock Control circuit for
an open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
CONVERTIBLE TOP 23 - 145