Chrysler 2005 Crossfire SRT6 Service Manual page 3388

21 - 318 AUTOMATIC - NAG1 SERVICE INFORMATION
a. Mount Special Tool 8901 (1) multi-disc holding
clutch B1 outer carrier (2).
b. Using a lever press, compress the pressing
tool as far as the stop (then the marking ring is
still visible, see small arrow).
c. Using a feeler gauge, determine the play "L" at
three points between the snap-ring (6) and
outer multiple-disc (4). During the measure-
ment, the snap-ring (6) must contact the upper
bearing surface of the groove in the outer mul-
tiple-disc carrier (5). The correct clearance is
2.3-2.7 mm (0.091-0.106 in.) for 2 friction disc
versions, 2.7-3.1 mm (0.106-0.122 in.) for 3
disc versions, and 3.0-3.4 mm (0.118-0.134 in.)
for 4 disc versions.
d. Adjust with snap-ring (6), if necessary. Snap-
rings are available in thicknesses of 2.6 mm
(0.102 in.), 2.9 mm (0.114 in.), 3.2 mm (0.126
in.), 3.5 mm (0.138 in.), 3.8 mm (0.150 in.),
and 4.1 mm (0.162 in.).
ZH