Chrysler 2005 Crossfire SRT6 Service Manual page 3629

ZH
9632 REAR BOW CYLINDER TRAVEL SENSOR (ROD SIDE) (+) SHORT CIRCUIT TO B(+) (CONTINUED)
• When Monitored: Continuous with the ignition on.
• Set Condition: When the Power Top Control Module senses a short to B(+) on the Rear Bow Cylinder
Travel Sensor (Rod Side) (+) circuit.
TRAVEL SENSOR (+) CIRCUIT SHORT TO B(+)
TRAVEL SENSOR
POWER TOP CONTROL MODULE
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.
Diagnostic Test
1.
Monitor the Rear Bow Cylinder Travel Sensor (Rod Side)
Turn the ignition on.
The Convertible Top must be up and locked.
With the DRB III , select Sensor Display and monitor the RR BOW
TRVL SEN ROD.
Does the DRB III display the RR BOW TRVL SEN ROD between
10 - 25 Counts?
Yes >> Go To 3
No >> Go To 2
2.
Rear Bow Cylinder Travel Sensor (Rod Side) (+) Short to B(+)
Turn the ignition off.
Disconnect the Power Top Travel Sensor harness connector.
Disconnect the Power Top Control Module C1 harness connector.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Rear Bow Cylinder Travel Sensor (Rod
Side) (+) circuit at the Power Top Control Module C1 harness connec-
tor.
Is the voltage above 1.0 volt?
Yes >> Repair the Rear Bow Cylinder Travel Sensor (Rod Side)
(+) circuit for a short to B(+).
No >> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
POWER TOP CONTROL MODULE - REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
Possible Causes
CONTROL MODULES/
CONVERTIBLE TOP 23 - 81