Chrysler 2005 Crossfire SRT6 Service Manual page 3437

ZH
FLUID
DESCRIPTION
No service required or recommended. Use fluid approved to MB 236.2. SAE 5W-20 meeting API SL or GF-3 Engine
Oil, such as Mopar part number 04761872AB, may be substituted.
STANDARD PROCEDURE
STANDARD PROCEDURE - FLUID DRAIN AND FILL
1. Raise and support the vehicle.
2. Remove the fill plug (1).
3. Place a suitable drain pan below the drain plug (2).
Remove the drain plug (2) and allow the transmis-
sion to drain completely.
4. Install the drain plug (2) and tighten to 60 N·m (44
ft. lbs.).
5. Remove the drain pan. Fill the transmission with
the specified fluid.
6. Install and tighten the fill plug (1) to 50 N·m (37 ft.
lbs.).
7. Lower the vehicle.
STANDARD PROCEDURE - CHECKING FLUID LEVEL
1. Raise and support the vehicle.
2. Remove the transmission fill plug (1).
3. The full fluid level should be at the base of the fill
plug threaded hole. If the fluid is low, check for vis-
ible transmission fluid leaks and top off the fluid
level.
4. Install and tighten the fill plug (1) to 50 N·m (37 ft.
lbs.).
5. Lower the vehicle.
MANUAL - SERVICE INFORMATION 21 - 367