Chrysler 2005 Crossfire SRT6 Service Manual page 2995

ZH
INSTALLATION
UPSTREAM O2
1. Apply anti-seize compound to the threaded portion
of the O2 sensor.
2. Install the O2 sensor (1). Tighten to 50 N·m (37 ft.
lbs.).
3. Connect the O2 sensor harness connector.
4. Install the engine cover. Align the engine cover
retaining clips to the rubber mounts, and push
down firmly to connect engine cover to rubber
mounts.
Note: To ease the installation of the engine cover,
apply a small amount of lubricant to the engine
cover rubber mounts.
5. Connect the negative battery cable.
INSTALLATION - DOWNSTREAM O2
1. Apply anti-seize compound to the threaded portion
of the O2 sensor.
2. Install the O2 sensor (1). Tighten to 50 N·m (37 ft.
lbs.).
3. Connect the O2 sensor harness connector.
4. Lower the vehicle.
5. Connect the negative battery cable.
FUEL INJECTION 14 - 57