Chrysler 2005 Crossfire SRT6 Service Manual page 3091

ZH
(P0600) ABS CAN MESSAGE MISSING (CONTINUED)
5.
CAN C BUS +/- CIRCUIT OPEN
Turn the ignition off.
Disconnect the CAB harness connector.
Disconnect the TCM C3 harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the CAN C BUS (+) circuit from the CAB
harness connector to the TCM C3 harness connector.
Measure the resistance of the CAN C BUS (-) circuit from the CAB
harness connector to the TCM C3 harness connector.
Is the resistance above 5.0 ohms on either circuit?
Yes >> Repair the faulty CAN C BUS circuit for an open.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Go To 6
6.
CAB - BRAKE MESSAGE MISSING
With the ignition off.
Replace the Controller Antilock Brake. (Refer to 8 - ELECTRICAL/
ELECTRONIC CONTROL
BRAKE - REMOVAL).
Turn the ignition on.
With the DRB III , erase Transmission DTCs.
Start the engine.
With the brakes firmly applied, shift the gear selector into drive.
With the DRB III , read Transmission DTCs.
Did DTC (P0600) ABS CAN MESSAGE MISSING set again?
Yes >> Replace the Transmission Control Module. (Refer to 8 -
ELECTRICAL/ELECTRONIC
TRANSMISSION CONTROL MODULE - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Test Complete.
MODULES/CONTROLLER
CONTROL
NAG1 - ELECTRICAL DIAGNOSTICS 21 - 21
ANTILOCK
MODULES/