Chrysler 2005 Crossfire SRT6 Service Manual page 3430

21 - 360 MANUAL - SERVICE INFORMATION
10. Disconnect the ground cable (1) at the transmis-
sion.
11. Remove the transmission to engine retaining
bolts.
12. Lower the transmission down and out of vehicle.
CLEANING
Clean the gears, shafts, shift components and transmission housings with a standard parts cleaning solvent. Do not
use acid or corrosive base solvents. Dry all parts except bearings with compressed air.
Clean the shaft bearings with a mild solvent such as Mopar degreasing solvent, Gunk or similar solvents. Do not dry
the bearings with compressed air. Allow the bearings to either air dry or wipe them dry with clean shop towels.
INSTALLATION
1. Position the transmission on the jack.
2. Install the transmission to the rear of the engine block. Align the transmission dowels to the engine block dowel
holes.
3. Connect the ground cable (1) to the transmission.
Tighten the bolt to 40 N·m (30 ft. lbs.).
4. Install the transmission to engine block retaining
bolts. Tighten the bolts to 40 N·m (30 ft. lbs.).
5. Raise the rear of the transmission.
ZH