Chrysler 2005 Crossfire SRT6 Service Manual page 3584

23 - 36 CONVERTIBLE TOP
9003/9004 POWER TOP CONTROL MODULE EEPROM ERROR (CONTINUED)
• When Monitored: Continuous with the ignition on.
• Set Condition: An attempt to program/write to the internal EEPROM failed.
POWER TOP CONTROL MODULE
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.
Diagnostic Test
1.
Power Top Control Module (PTCM)
Note: This DTC indicates an internal PTCM fault.
With the DRBIII , read and record the PTCM DTCs and then erase
the PTCM DTCs
Perform 3 ignition key cycles, leaving the ignition key on for a mini-
mum of 30 seconds per cycle.
With the DRBIII , read the PTCM DTCs.
Did this DTC set again?
Yes >> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
POWER TOP CONTROL MODULE - REMOVAL)
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> The condition that caused this DTC to set is currently not present.
Perform POWER TOP CONTROL MODULE VERIFICATION TEST.
Possible Causes
CONTROL MODULES/
ZH