ZH
INSTALLATION
1. Install the reservoir if it was removed, by inserting the C-clip using a suitable tool.
2. Install the power steering pump and bolts (3) to the engine block. Tighten to 20 N·m (15 ft. lbs.).
3. Install the high-pressure hose (2) on the pump.
4. Install the return hose on the pump.
5. Install the power steering supply line (6) to the reservoir.
6. Install the accessory drive belt (1). (Refer to 7 - COOLING/ACCESSORY DRIVE/DRIVE BELTS - INSTALLA-
TION).
7. Fill the power steering pump reservoir and then bleed the system by performing the initial operation. (Refer to 19
- STEERING/PUMP - STANDARD PROCEDURE).
PUMP 19 - 69