Chrysler 2005 Crossfire SRT6 Service Manual page 3158

21 - 88 NAG1 - ELECTRICAL DIAGNOSTICS
(P0710) TRANS TEMP SENSOR SHORTED (CONTINUED)
5.
TEMP SENSOR - P/N SWITCH CIRCUIT SHORT TO GROUND
Turn the ignition off.
Disconnect the TCM C2 harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Temp Sensor - P/N
Switch circuit.
Is the resistance above 100 kohms?
Yes >> Go To 6
No >> Repair the Temp Sensor - P/N Switch circuit for a short to
ground.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
6.
TEMP SENSOR - P/N SWITCH CIRCUIT SHORT TO OTHER CIRCUITS
With the ignition off.
Disconnect the TCM C1 harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance from the Temp Sensor - P/N Switch circuit to
all other circuits in the TCM C1 and C2 harness connectors.
Is the resistance above 100 kohms for all measurements?
Yes >> Replace the Transmission Control Module. (Refer to 8 -
ELECTRICAL/ELECTRONIC
TRANSMISSION CONTROL MODULE - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Repair the Temp Sensor - P/N Switch circuit for a short to
other circuit(s).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
CONTROL MODULES/
ZH