Chrysler 2005 Crossfire SRT6 Service Manual page 3261

ZH
RR WHEEL SPIN CAN MESSAGE NOT VALID (CONTINUED)
ABS WHEEL SPEED SENSOR DTC PRESENT
CONTROLLER ANTILOCK BRAKE MODULE
SHIFT LEVER ASSEMBLY
For a complete Shift Lever Assembly Circuit Diagram, (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC -
NAG1 - SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
CAN BUS OR ABS DTC PRESENT
Turn the ignition on.
With the DRB III , read the ABS DTCs.
Are any CAN Bus or Wheel Speed Sensor DTCs present?
Yes >> Refer to the Brakes - ABS Electrical Diagnostics category
and perform the appropriate symptom.
No >> Go To 2
2.
CAB – ABS RR SENSOR MESSAGE
Turn the ignition off.
Replace the Controller Antilock Brake Module. (Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/CONTROLLER ANTILOCK
BRAKE - REMOVAL).
Start the engine.
Road test the vehicle.
With the DRB III , read ABS DTCs.
Did DTC RR WHEEL SPIN CAN MESSAGE NOT VALID set
again?
Yes >> Replace the Shift Lever Assembly. (Refer to 21 - TRANS-
MISSION/TRANSAXLE/AUTOMATIC
MECHANISM - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Test Complete.
NAG1 - ELECTRICAL DIAGNOSTICS 21 - 191
POSSIBLE CAUSES
- NAG1/SHIFT