Chrysler 2005 Crossfire SRT6 Service Manual page 3554

23 - 6 BODY - ELECTRICAL DIAGNOSTICS
REAR SPOILER SWITCH SENSE CIRCUIT (CONTINUED)
2.
BCM
Turn the ignition off.
Measure the resistance between ground and the Rear Spoiler Switch
Sense circuit at the BCM C4 harness connector.
Is the resistance below 100K ohms?
Yes >> Go to 3
No >> Replace the Body Control Module.(Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL).
Perform REAR SPOILER VERIFICATION TEST.
3.
REAR SPOILER SWITCH SENSE CIRCUIT SHORT TO GROUND
With the ignition off.
Disconnect the Rear Spoiler Switch harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Rear Spoiler Switch
Sense circuit at the BCM C4 harness connector.
Is the resistance below 100K ohms?
Yes >> Repair the Rear Spoiler Switch Sense circuit for a short to
ground.
Perform REAR SPOILER VERIFICATION TEST.
No >> Replace the Rear Spoiler Switch.
Perform REAR SPOILER VERIFICATION TEST.
ZH